Davies Jet Pressure System – Hydrogenie Controller

The Davies Cast Iron JET series pumps with their proven reliability and excellent self-priming ability, combined with a Hydrogenie 3.1,  4.1 or 5 controller for complete pump control and protection makes them a valuable asset to any house or farm water supply system. Jet/venturi design allows suction lift up to 8m – great for drawing from rivers, dams & ponds, shallow wells/bores and underground tanks. Easy to prime and handle suction air leaks. Rugged cast iron pump casing for greater strength.
Supplied with:

• Hydrogenie 3.1, 4.1 or 5 controller
• Brass Connection Union
• Models with HG5 controller must be fitted with appropriately sized pressure tank. It is recommended to install a pressure tank with the HG3.1 and HG4.1 controllers.

Controller Features:
HYDROGENIE 3.1

• Pump managed by power relay.
•  Accumulation membrane and Integrated non-return valve.
• Dry-running protection.
• Digital pressure gauge (bar and psi).
• Inner pressure transmitter
• Inner flow sensor.
• Stand-by mode.
• ART function (Automatic Reset Test). If the device has been stopped due to the action of the safety system against dry operation, the ART tries to connect the pump, with a programmed periodicity because the water supply could have been restored.
• Control panel includes 3 digits display.

HYDROGENIE 4.1

• Max pressure: 8Bar.
• Operating temperature range: -0 to +60ºC.
• Connection Thread: 1 1/4” male.
• Minimum pump pressure: 1.0Bar.
• Motor overload protection – adjustable.
• Start pressure adjustable from 0.5 – 7.0bar.
• Stop pressure (if in Pressure dependent mode) adjustable 1 to 8bar
• Automatic reset/restart following run dry: If the pump runs dry the controller will attempt to re-prime after 5 minutes. consecutive attempts are performed every 30 minutes.

HYDROGENIE 5

• 230V Single phase or 400v Three phase
• Max 10A rated (per phase)
• Max 10bar rated
• Motor overload protection
• Over and under voltage protection
• Short between phases protection
• Run Dry protection
• Auto restart function
• Start pressure range 1-5bar (on/off mode)
• Max start pressure 6.5bar (pressure dependent mode)
• Max stop pressure 7 bar (pressure dependent mode)
• IP55 protection
• Adjustable start and stop delay
• Instantaneous digital screen displays: Line pressure, set pressure, Amp draw, Flow sensor position, controller temperature

Note: A pressure tank is required, size depends on application and controller mode (on/off or pressure dependent). Please call Argon to assist with correct size pressure tank.

3 Year Warranty